PTV Group - Logistics Forum

Posted: **Tue Feb 20, 2018 2:00 pm**

I use the code as below in order to set the desire to use the road type.

   XElement BasicDataRules = new XElement("BasicDataRules", new XElement("Network",
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[0])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[1])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[2])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[3])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[4])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[5])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[6])),
                new XElement("MalusByNetworkClass", new XAttribute("malus", malus[7]))
                ));

In the documentation I read that these values are for the eight basic types of roads. Could you tell me name of this roads?(Urban etc ?)

Posted: **Tue Feb 20, 2018 4:18 pm**

Hi there,

: Network classes
MOTORWAY 0 Motorways
HIGHWAY 1 Highways
TRUNK_ROAD 2 Trunk roads
COUNTRY_ROAD 3 Country roads
CITY_ROAD 4 City roads
RESIDENTIAL_ROAD 5 Residential roads
SPECIAL_ROAD 6 Drivable but normally blocked roads (for cars).
CYCLE_AND_WALKWAY 7 Cycle lanes and walkways

http://xserver.ptvgroup.com/fileadmin/f ... %7C_____14

Best regards,
Bernd

PTV Group - Logistics Forum

settings for roads

settings for roads

Re: settings for roads