Page 1 of 1
PTV_TrafficIncidents parametrization
Posted: Mon Sep 23, 2019 1:19 pm
by krzysiek mbis
Hi,
PTV_TrafficIncidents takes into consideration data like: traffic, road blocks (becouse it can be uder costructions) etc.
Is there a way to turn of traffic data from that and have all of the rest ?
Best Regards,
Krzysztof
Re: PTV_TrafficIncidents parametrization (XSERS-1540)
Posted: Mon Sep 23, 2019 2:38 pm
by Bernd Welter
Hi,
at least xServer2 offers the possibility to display/detour only time dependent blockings that match certain conditions, e.g. only blockings thar are relevant over the complete next 24hours (construction) and to suppress short terms (accidents which will be "cleaned" 2 hours from now).
Is
this what you need?
Best regards,
Bernd
Re: PTV_TrafficIncidents parametrization
Posted: Tue Sep 24, 2019 12:19 pm
by krzysiek mbis
Hi,
It looks like, at least I would like to test it. But "I think" that we have xServer not xServer 2.
To be honest I don't know how to check it, can You tell me how to do it?
If I have xServer -> can I use xServer2 ? How can I do it ?
Best regards,
Krzysztof
Re: PTV_TrafficIncidents parametrization
Posted: Wed Sep 25, 2019 7:17 am
by Bernd Welter
Hi,
you can get access to the
test platform of xServer 2 via a token which you can request at this
registration form.
The WSDLs are listed
here.
For an on premise installation you need to get in touch with your sales counterpart at PTV and request it from him/her.
Best regards,
Bernd